Panniers for XDS e-spresso

6zfshdb

Well-Known Member
You can make a frame "adapter" with pieces of 1/2" aluminum tubing and appropriate size insulated cable clamps.

39792 The 1/2" size clamps are required for the tubing and the 5/8" size will fit most oversize bike frames.


39793 A 12" length of tubing is usually adequate for most panniers. It is available on Amazon but could be obtained locally at a better price


39794 For a finished look, these plugs can be used on the tubing ends.


39795 39796 39797 39798

Installation is simple requiring only a screwdriver and pliers. A hacksaw may be necessary if the 12" tubing needs to be shortened.
 
Last edited:

zuzuspetals

New Member
You can make a frame "adapter" with pieces of 1/2" aluminum tubing and appropriate size insulated cable clamps.

View attachment 39792 The 1/2" size clamps are required for the tubing and the 5/8" size will fit most oversize bike frames.


View attachment 39793 A 12" length of tubing is usually adequate for most panniers. It is available on Amazon but could be obtained locally at a better price


View attachment 39794 For a finished look, these plugs can be used on the tubing ends.


View attachment 39795 View attachment 39796 View attachment 39797 View attachment 39798

Installation is simple requiring only a screwdriver and pliers. A hacksaw may be necessary if the 12" tubing needs to be shortened.
Thanks very much for your reply and advice. I think I'll give that a go!