ST1 X - Torque value to tighten torque sensor ?

Salade

New Member
Hi,

Do you know the torque value to tighten the torque sensor screws (A,B and C) shows on attached image ?
I bought a torque wrench and I noticed that the rear wheel was initialy tightened more than 30 Nm while the value is 20 Nm.

Regards
 

Attachments

smitty

Active Member
Component ST2S ST2 Torque

Clamping handles (Ergon GS1-L) – handlebar * * 5 Nm

Clamping brake lever (Tektro) – handlebar - * 5 – 7 Nm

Clamping brake lever (Magura) – handlebar * * 4 Nm

Clamping gear lever (Shimano SLX) – handlebar - * 3 Nm

Clamping gear lever (Shimano Alfine Di2) – handlebar * - 5 – 7 Nm

Clamping stem - handlebar * * 6 Nm

Clamping stem – steer tube (carbon) * * 5 Nm

Clamping headset top cap – steer tube * * 3 Nm

Clamping saddle underframe * * 13 – 15 Nm

Clamping saddle angle * * 10 – 12 Nm

Clamping saddle clamp – frame – saddle post * * 10 Nm

Front axle * * 20 Nm

Rear axle * * 20 Nm

Brake disk (6-hole, Tektro) - * 6 – 8 Nm

Brake disk (6-hole, Magura) * * 4 Nm

Brake disk (4-hole, Syno Drive HR-Hub) * * 7 Nm

Bottom bracket, FSA MegaExo * - 40 – 50 Nm
 

Salade

New Member
Hi Smitty,
Thank you for the answer.
I was aware of these values but the screws A,B and C are not in this list (according to me)
Regards
 
Last edited: