Recent content by kattanm

  1. kattanm

    FIXED: How do you add rider power to Garmin on Specialized Creo SL?

    My Creo and my Roubaix give quite similar power readings. Nothing like double on the Creo.
  2. kattanm

    FIXED: How do you add rider power to Garmin on Specialized Creo SL?

    And on your Garmin device you’re reading the sensor of the bike’s power meter? Also the e-bike sensor is not connected, and in Mission Control, the fake channel is disabled? That’s my setup and reads about right.
  3. kattanm

    Creo Remote Control DIY

    Oh wow please video this. So left shifter will be assist up and down?
  4. kattanm

    Creo SL 1x Chainguide?

    Hi, how does one check this?
  5. kattanm

    Have you tried to lighten your Vado 5 SL?

    Like, upgrade the wheelset, switch to some carbon components? If you have tried to get the weight down, what did you do, and how far did you get?
  6. kattanm

    Creo 1X drivetrain - Has frustrated me for some time

    I moved to 11-38 and am much happier with the gaps
  7. kattanm

    2021 Creo Road Remote?

    Uh oh now I have a new problem. After installing the assist buttons, my left shifter is essentially dead — doesn’t do anything. Even the top button doesn’t change Garmin pages. When I go into the e-tube project software, I see my two shifters. My goal for the left is to have the larger...
  8. kattanm

    2021 Creo Road Remote?

    Yes! Can you send me an amazon link to finishing tape? This is not my speciality here... That port came from my Specialized dealer — did not come with bike originally.
  9. kattanm

    2021 Creo Road Remote?

    Here is my setup. On the bend lines up with outstretched middle finger. Used double wrap under the hoods while keeping buttons exposed. Routed cable drive side.
  10. kattanm

    Creo Remote Control DIY

    Ugh that’s a bummer. In theory, it should be the same exact solution right? Same wires, plugs, holes, etc.?
  11. kattanm

    Creo Remote Control DIY

    What about this idea: if you had an extra piece of e-tube, what if you spliced the e-tube plug to the FSR cord (after cutting off the Levo remote). Then, could you just unplug the e-tube currently going into the shifter and plug in your new e-tube plug that is fused to the FSR cord? That would...
  12. kattanm

    Creo Remote Control DIY

    What's the significance of the red arrow on the right? I see the left one pointing at the wires that need connecting...
  13. kattanm

    Creo Remote Control DIY

    Oh wow this gets more interesting by the post! How did you expose the colored wires from each end? Just a sharp pocket knife? This is DIY to the max!
  14. kattanm

    Creo Remote Control DIY

    Oh wow this is the most bad ass post I’ve ever seen. Damn. Can you please add a pic pointing to the two screws in the first step, a pic of a mounted shifter? Also, did you solder the wires when connecting the Levo cable to the di2?