36v hall effect voltage same as 48 v hall effect?

tomjasz

Well-Known Member
I'm trying to get my Mac12t apart
1629134558892.png
 

indianajo

Well-Known Member
Got the tamper proof screws off the bafang 500 w motor with a 1/32" die grinder wheel to cut a slot, and a DAF center punch to start them left. Then flat blade screwdriver.
Bafang stator is in a pot. Pulled cover stator & shaft. Can see the hall effect wires, note colors, cut Julet connector off and put .157" bullet connector on phase wires & white 6 hole block on +5, G, 3 hall effect pickups.
Don't have a puller big enough for Mac cover now. Lost $45000 tools+electronics 9/14/20. Six pullers went to fence. Replacing one tool at a time.
 

tomjasz

Well-Known Member
Got the tamper proof screws off the bafang 500 w motor with a 1/32" die grinder wheel to cut a slot, and a DAF center punch to start them left. Then flat blade screwdriver.
Bafang stator is in a pot. Pulled cover stator & shaft. Can see the hall effect wires, note colors, cut Julet connector off and put .157" bullet connector on phase wires & white 6 hole block on +5, G, 3 hall effect pickups.
Don't have a puller big enough for Mac cover now. Lost $45000 tools+electronics 9/14/20. Six pullers went to fence. Replacing one tool at a time.
Why not get the right driver tip? $6-$20

I’ve only used 3 or four but as they’re become more common I like having proper drivers.
D1EE32F1-34B2-443E-95A8-0A5F7915DE20.png