Brake wire extension for cut-off switch

David Paisley

New Member
I have Tektro hydraulic e-bike brakes with the motor cut-off switch built into the handles. The wires connecting the brake handle to the computer controller are too short as I want to change out the handlebar. I am looking for a short extension wire, 2 pin male/female. 6 inches, or 10 cm would do. Or looking for a source. The bike is the Magnum Navigator with a C7 computer if that helps.
 

Attachments

  • brake cutoff wire1.2.jpg
    brake cutoff wire1.2.jpg
    173.1 KB · Views: 24
  • brake cutoff wire2.jpg
    brake cutoff wire2.jpg
    351.7 KB · Views: 21