Known Issues & Problems with ECOTRIC Products + Help, Solutions & Fixes

Ratbuilder

New Member
The KT controllers have 5 level assist. It smooths out the rougher 3 level of the 810LED.
I am sorry for being such a question type of guy, but the link confuses me. I do want to order the whole kit, is the part # 6MOSFET? Does the kit contain a KTLCD8H display? Do you have to order each part separately, or will it all be in the kit? See, I am just chuck-full of questions.

Thanks harryS. You said what you said about the throttle so that I would not need to remove the hand grip? I am ok with splicing the wires, I ALWAYS solder and heat-shrink all wire splices.
 

Ratbuilder

New Member
I am sorry for being such a question type of guy, but the link confuses me. I do want to order the whole kit, is the part # 6MOSFET? Does the kit contain a KTLCD8H display? Do you have to order each part separately, or will it all be in the kit? See, I am just chuck-full of questions.

Thanks harryS. You said what you said about the throttle so that I would not need to remove the hand grip? I am ok with splicing the wires, I ALWAYS solder and heat-shrink all wire splices.
Ok Harry, now the questions start. I got the controller kit today, and today I started to take the 20" apart. Question #1.....The brake lever wires (2) Blue and red coming from the levers go too different colors on the controller. (810) Blue to black and red to purple. Since it is just s 2 wire switch, it must open the circuit when you apply the brake. On the NEW controller the only 2 wire connector is red and blue, but there is just one. It Ys to another 2 wire connector, and the 2 are then Y into a 3 wire connector. All of these connectors start from 2 wires Green and blue coming from the controller. This set-up is for the purpose of putting the 2 brake switch in series, or am I off in left field about this?

On the 810 controller, the small wires going to the rear hub are 5 in number. The wires from the connector to the hub total 6. The new square connector on the NEW controller had 6 wires from the controller. They have the same colors as the wires from the connector to the hub. Do I just look the same colors to each other?

Can I use the same signal generator that is on the peddles for the NEW controller, or do I need to figure out how to attach the larger wheel with the magnets and the pickup to the peddles? The main wires look like a no-brainer. Red and Black to red and black, and blue green and yellow to blue green and yellow. The throttle red white and black go to the only red white and black connector on the NEW controller. Is this correct?

The NEW display will plug into a connector on the NEW controller.

This leaves 2, three wire connectors (red black and yellow) that are Y into 1 red 1 black, and 1 yellow that come from the NEW controller, without a home.

Also there is a red, black, and blue, 3 wire connector without a home. also on the same sub assy there is a 3 wire connector with brown, yellow, and black, that have no home.

I also am confused as to how to hook up the brake switch wires.

Please don't hate me Harry. I have done other wiring jobs, but this one scares me just a little. LOL
 

harryS

Well-Known Member
I am going to put your questions in another topic.. It will be easier to answer. ANyone else is free to join the discussion!
Click here or below

 
Last edited: